Note:
This vehicle is normally fitted with bulb failure monitoring for which we
recommend wiring the parking sensor kit via a Single Bypass Relay available from
our Accessories section.
Fitters comments:
"very difficult to find an area on the car to mount the cpu due to too
many computers generating too much noise, eventually found a quite
place by the n/s headlamp assy, placed in a weatherproof box & attached
to the plastic inner wing, a smart switch was also fitted to this
vehicle taking it's supply using a piggy back fuse holder pushed into
the fuse board, a grommet is to be found in the bulkhead after removing
all the plastic windscreen scuttle & pollen filter assy, reverse lamp
feed can be found running down carpet side of the drivers sill under the
plastic door sill trim this wire is purple/black (check with a digital
multimeter only) beeper mounted in a convenient place in the fuse board
area."
Please note that these photo's are of customers' vehicles and should be used for informational purposes only, the installation instructions supplied with the Parking Sensor kit should be adhered to at all times.
Please Note that Parking Sensor systems are designed to be a drivers aid and should not replace the need to drive carefully, we will not accept liability for damage or loss resulting from improper installation or use of this product, infringement of the vehicle manufacturer’s warranty or injury or loss resulting from any accidents however caused.